Synergy 8.6 m Concealed Floor System

 Acousto-Magnetic (AM)

The Sensormatic Synergy 8.6 m Concealed Floor System delivers exceptional yet discreet, Acousto-Magnetic (AM) EAS protection for wide retail environments. This system provides protection for exits up to 8.6 m (28.5 ft) and a vertical detection zone of up to 1.2 m (4 ft), emitting an audible alert to notify store assistants if protected merchandise passes through the detection zone. For existing retail environments, the AMS3030-A/AL is an ideal solution. Installation simply requires floor cuts in concrete where the antenna cabling is placed. Once secured, flooring material is then applied over the antenna. The AMS3031-A/AL version is intended for pre-construction installation. Its setup protects detection antennas against possible interference if metal or rebar is discovered below the subfloor. Both installation options deliver AM EAS detection for wide exits or open architecture requirements. The optional 3D Overhead Traffic Counting Sensor can also be integrated and configured to provide visibility into shopper visits in order to help drive incremental sales and improve conversion rates.

Retailer Values

• Delivers exceptional protection for wider exits to help maximise flow and optimise floor space
• Enhances loss prevention efforts and increases shopper visibility through network connected storefront alarms and traffic intelligence
• For minimal impact on store operations, AMS3030-A/AL antenna installation eliminates costly, large-scale excavations
• Helps to protect detection antennas against possible interference if metal or rebar is discovered during construction installation for optimal system performance (AMS3031-A/AL only)
• Enhances the shopper experience and maximises storefront floor space with ‘tags-too-close’ feature
• Helps to reduce shrink by notifying staff of the presence of a jammer device with a distinct audible alarm

Product Compatibility
Sensormatic AM sensors
Synergy Pedestals
Pro-Max
Door-Max
Ranger Receivers
Satellite Receivers
Amorphous Core Receiver
3D Overhead Traffic Counting Sensor
Wireless Device Manager
Wireless Module
Shrink Management as a Service
 

Specifications
AMS3030-A/AL & AMS3031-A/AL
Capacitor Board Enclosure
Length................................47.5 cm (1.55 ft)
Width ................................ 37.8 cm (1.24 ft)
Depth................................... 8.5 cm (3.3 in)
Weight .................................2.4 kg (5.25 lb)
AMS3031-A/AL
AMS3031-A Floor Loop Antenna
Length (w/o coupling) ...... 172 cm (5 ft 7 in)
Length (w/coupling) ...... 176.9 cm (5 ft 9 in)
Width .............................. 93.6 cm (3 ft 1 in)
Height (at coupling).............. 4.3 cm (1.7 in)
Weight (conduit & wires) ....... 8.6 kg (19 lb)
 

Power Supply (AMS9060)
Electrical
Primary Input
100-120 VAC or 220-240 VAC @ 50-60Hz
Primary Power Fuse
3.15 A, 250 V, slo-blow, hi-breaking
Current Draw
(120 V) <1.13 Arms
(240 V) < 0.72 Arms
Input Power
(120 V) <82.1 W
(240 V) <90.0 W
 

Transmitter
Operating frequency ........58 kHz (±200 Hz) (sync pulse 56 kHz)
Transmission burst duration............. 1.6 ms
Max. transmission current...........20 A peak
Burst Repetition Rate
Based on 50 Hz ac ............ 75 Hz or 37.5 Hz
Based on 60 Hz ac .............. 90 Hz or 45 Hz
Receiver
Centre frequency ....................58 kHz Floor Antenna (Tx/Rx)
Cable....................4-conductor, shielded, b urial-rated
Cap box Tx/Rx cable................ 13 m (40 ft), 4-conductor, shielded, direct-burial, plenum-rated
Cap box comm cable .............. 13 m (40 ft), 4-conductor, shielded, plenum-rated
 

Environmental Constraints
Operating temperature
0°C to 50°C (32° to 122°F)
Relative Humidity
0 to 90%, non-condensing
Enclosure
IPX0
Evaluated for altitudes up to 3200 m
(10500 ft)
 

Declarations
EMC
47 CFR, Part 15
RSS 210
Safety 
UL/EN 60950-1
CSA C22.2.60950-1